Injection Moulding, Injection Molding (Machine)

Kenplas Forum ==> Injection Molding (Machine) ==> Injection Moulding

WE have 3 -16 cav moulds ea .for spoon , Fork and Knife . The wall thickness in the handle area is 10 mm . All valve gate ( Husky ) and gates are 2.5 mm. We are not able to eliminate flow marks on the part . ( Near the gate , opposite to the gate ) . Can I have expert opinion as to the possible solution to this . Thanks - Mike

2015-2-11 2:11:48 By mike sanghvi


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.